Filter
Top Products
2
Before use
2-12 C450
2.4.2 Program
Registering into the [Program] the destination and communication functions,
you can call the information of registration only by pressing the [Program]
key.
!
Detail
You can register the scan setting and comm. setting functions. For de-
tails, refer to “Registering the program” on page 10-25.
Program
This section describes procedures for registering into the [Program] the reg-
istration name and destination.
1 Press [Utility/Counter] on the control panel to open the utility mode
screen if it is not already displayed.
– For the program, up to 400 (001 to 400) can be registered.
2 Press [One-Touch Registration].
– In the utility mode, it is also possible to enter a number displayed in
the key through the keypad for selection. In the case of [One-Touch
Registration], enter the “1” on the keypad.
3 Press [Fax].
4 Press [Program].