Filter
Top Products
1-5
Section 1 Fax Operation (Basic Use)
2
3
4
5
1
2
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
6
Touch the “FAX default” key.
Touch the “▼” cursor key until “TTI” is highlighted and then
touch the “Change #” key.
If you want your TTI information to be sent to the other party,
touch the desired location where you want it to be printed.
If you do NOT want it to be sent, touch the “Not Printed” key.
Touch the “Close” key. The message display will return to the
same screen as was displayed in step 3.
If you are finished making settings, touch the “Close” key 2
more times.
(3) Registering Your Self-Station
Information
If you register information identifying your station (fax number, station
name and station ID) here, it can be sent to the receiving party's fax
and printed on the received documents, thereby instantly notifying
that party of the source of the fax transmission.
* Use the following procedure as well when you want to change
information that is already registered.
* Prior to operation, check the message display to make sure that the
touch panel is in the initial mode for fax operation.
(Refer to “(2) Initial Mode” on page 1-7.)
* If you want to cancel the procedure part way through, press the
Reset key.
Touch the “Register” [“Registration”] key. The Registration
Select screen will appear.
Touch the “Location Info.” key. The currently registered
information will be displayed.
* To register your fax number: Touch the “v” key and go to
step 3.
To register your station name: Touch the “Own Name” key
and go directly to step 5.
To register your station ID: Touch the “Own ID” key and
proceed directly to step 7.