Filter
Top Products
Chapter 3 Using the Operator Panel
3-20
Display the desired baud rate and press the
ENTER
key.
Press the
MENU
key. The message display returns to
Ready.
Q
QQ
Q Changing Network Interface Parameters
This printer is equipped with the network interface.
For details on networking, refer to the “Quick Configuration
Guide”.
Press the MENU key.
Press the 3 or 4 key repeatedly until Interface >
appears. One of the interface names shown below ap-
pears, indicating the current interface.
Parallel (default)
Serial
Network
Option (only when an optional network interface
card is installed)
Press the ENTER key. A blinking question mark (?) ap-
pears.
Press the 3 or 4 key repeatedly until Network ap-
pears.
Press the
ENTER
key again.
Press the 2 key. Each time the 3 or 4 key is pressed,
the display changes as shown below.
The following example explains how to activate TCP/IP
protocol to connect the printer in the network. You can
select Netware or EtherTalk in a similar manner.
If TCP/IP is currently displays Off, select On using the
3 or 4 key. Press the ENTER key again.
Interface
?Parallel
Interface
?Network
9
10
1
2
3
4
5
>NetWare
On
>TCP/IP
On
>EtherTalk
Off
>Network Status
Page On
If turns ON, print the
standard Network Inter-
face Status Page after
the Printer Status Page.
See
page 3-10
.
>Opt. StatusPage
On
If turns ON, print the op-
tional Network Interface
Status Page after the
Printer Status Page.
See
page 3-10
.
>TCP/IP >
On
>TCP/IP
? Off
>TCP/IP >
On
6
7