Filter
Top Products
Appendix C Host Computer Interface
C-5
The Properties sheet is displayed for the selected
COM port. Click on the Port Settings tab and set the
port properties.
After setting the properties, click the OK button.
Q
QQ
Q DOS
Enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are
temporary. On most computers, permanent settings must be
made with DIP switches.
If you want to use a different baud rate or change any of the other
RS-232C parameters, this can be accomplished from the print-
er’s operator panel. See Changing the Interface Parameters on
page 3-18.
5
6
1
2