Filter
Top Products
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P v2
3-6 Connecting the FWG114P v2 to the Internet
201-10301-02, May 2005
2.
RESTART YOUR NETWORK IN THE CORRECT SEQUENCE
Warning: Failure to restart your network in the correct sequence could prevent you from
connecting to the Internet.
a. First, turn on the broadband modem and wait 2 minutes.
b. Now, turn on your wireless firewall/print server.
c. Last, turn on your computer.
Note: If software usually logs you in to the Internet, do not run that software, or cancel it if
it starts automatically.
Figure 3-4: Verify the connections to the firewall
d.
Check the status lights and verify the following:
• Power: The power light goes on when your turn the wireless firewall/print server on.
• Test: The test light turns on, then goes off after less than a minute.
• Local: A Local light on the router is lit. If no Local lights are lit, check that the
Ethernet cable connecting the powered on computer to the router is securely attached
at both ends.
• Internet: The Internet light on the wireless firewall/print server is lit. If the Internet
light is not lit, make sure the Ethernet cable is securely attached to the wireless
firewall/print server Internet port and the powered on modem.
ProSafe 802.11g Wireless Firewall/Print Server
Broadband
MODEL
FWG114P
PWR
PRIN TER MO DEM INTERN ET LOCAL W LAN
TEST
ACT
ALERT
ACT
LINK
100
1234
LNK/ACT
100
LNK/ACT
Power Test
Internet Port
Local Port 4