Panasonic A4P Series Power Supply User Manual


 
100
How to Use the Console
Clearing of Absolute Encoder
Only applicable to the system which uses absolute encoder. You can clear the alarm and multi-turn data of
the absolute encoder.
Clearing of absolute encoder starts
Clearing finishes
Error occurs
(
When non-applicable encoder is
)
connected
Clearing of absolute encoder 
completes
<Remarks>
Don't disconnect the console from the driver between to .
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Notice>
If an error code No. 40 is shown on the console immediately after purchase, clear the absolute encoder
through the console.
Press five time after pressing , to setup auxiliary function mode, 
then with , make a display to
Press to call for 
EXECUTION DISPLAY of
Then keep pressing until the display of Console (LED) 
changes to
“ ” increases by 
pressing (approx. 5sec) 
as the left fig. shows.
SELECTION display
When you have cleared the absolute encoder, press to return to .
A incremental encoder or any
unsupported encoder other than an
absolute encoder may be connected.
Reset the power supply and clear the
error.
Operation at SELECTION display
Operation at EXECUTION display