Administrator’s Guide for the V500 System
4 - 10 www.polycom.com/videodocumentation
Configuring General Audio Settings
To configure general audio settings:
1. Go to System > Admin Settings > Audio.
2. Configure these settings:
Setting the Volume on an External Audio System
If you have connected an external audio system, you may need to adjust its
volume.
To set the volume:
1. Go to System > Diagnostics > Audio > Speaker Test.
2. Adjust the external audio system’s volume so that the tone is as loud as a
person talking in the room.
After you do this, you can adjust volume levels using the V500 system’s remote
control.
Setting Description
Master Audio Volume Sets the volume level for audio from the far site.
Sound Effects
Volume
Sets the volume level of the ring tone and user alert tones.
Incoming Video Call Specifies the ring tone used for incoming calls.
User Alert Tones Specifies the tone used for user alerts.
Bass Sets the volume level for the lower frequencies without changing
the master audio volume.
Tre ble Sets the volume level for the higher frequencies without
changing the master audio volume.
Mute Auto-Answer
Calls
Specifies whether to mute incoming calls.
If you select this option, incoming calls are muted until you press
the Mute button on the remote control.
Enable Internal
Ringer
Specifies an additional ring tone when receiving an incoming
call.
The ringer is built into the system and will alert you to incoming
calls even if the TV monitor connected to the system is powered
off.