Filter
Top Products
Programming7–18
Slewing a Specified Number of Lines
To slew a specified number of lines, set Configuration Option 25 to either
25.0 or 25.1, and Configuration Options 60 and 61 to enable the use of the PI
line for EVFU control. Also, program the host computer to send a paper
instruction (PI) and a Hex code that represents the number of lines to slew.
Table 7–6 shows the relationship between the configuration, the Hex code,
and the resultant number of lines slewed. The example shown in Figure 6–2
on page 6–10 in the EVFU chapter is repeated in using line slew without
EVFU loaded.
NOTE: Set Configuration Option 25 to 25.0 for systems that require Hex
code 10 to equal a one line slew.
Table 7–6. Slew Codes with Paper Instruction Signal
(Configuration Option 60.2 and 61.1)
Paper
Instruction Code
No. of Lines Slew/Configuration Option
Hex 25.0 25.1
1 10 1 1
1 11 2 1
1 12 3 2
1 13 4 3
1 14 5 4
1 15 6 5
1 16 7 6
1 17 8 7
1 18 9 8
1 19 10 9
1 1A 11 10
1 1B 12 11
1 1C 13 12
1 1D 14 13
1 1E 15 14
1 1F 16 15