Filter
Top Products
Operation3–14
6. Adjust the right tractor so that the paper has just enough tension to be
flat and taut without pulling. Pull the right tractor up to lock it.
NOTE: Too much or too little paper tension may distort the sprocket holes
and cause problems in paper feeding or printing.
7. Advance the paper with the positioning knob so the paper will feed out
of the opening between the raised cover and the top of the printer. Make
sure the paper supply from the bottom will feed into the printer in a
straight line.
Positioning Knob
8. Adjust the forms thickness adjustment lever to the appropriate paper
thickness. Refer to “Paper Type and Thickness” on page 3–11.
Pointer
9. If the power was on while you loaded the paper, press the CHK switch.
If the power was off, turn the power on and then press and release the
RDY switch.
10. Set top–of–form (TOF). Top–of–form should be set each time the paper
is loaded, refer to “Setting Top–of–Form” on page 3–16.