Filter
Top Products
2–11
Installation
Table Top Mounting
The MVP–Series printers can be mounted on a sturdy table instead of the
pedestal. However, the table must be designed or modified to accommodate
the printer paper path and proper air ventilation.
1. Select a table sturdy enough to support the weight of the printer. If the
table is not designed for a bottom feed paper path and proper air
ventilation modify the table.
2. Make sure the four rubber feet are firmly attached to the base of the
printer.
3. Position the printer on the table so the paper will feed from under the
table, through the paper path slot, and up into the paper guide of the
printer. The paper should pass through the slot with 1/2 inch clearance at
both ends.
4. Assemble the paper tray (if used) according to the instructions in
“Assembling the Paper Tray” on page 2–8, and position it behind the
printer. Push the ground cable connector onto the protruding metal tab
located on the back of the printer, to the right of the power connector.