Filter
Top Products
3–Interactive Commands
Utilities Menu
SN0054614-00 K 3-65
Update Flash (Per Adapter Port or All HBAs)
(Command Line Option -b)
10: Utilities 1: Update Flash
When you select Update Flash, you are prompted to select either one of your
adapter port instances or All HBAs to update. SANsurfer FC/CNA HBA CLI then
prompts you to Update Entire Image, to enter a file name (.bin) for the Flash
update file, and to confirm the operation. The Flash update progress appears as
in the following example:
Validating Flash Image File...
BIOS Version : 2.11
Driver Firmware Version : 5.01.01
Flash BIOS Version : 2.11
Flash FCode Version : 3.01
Flash EFI Version : 3.10
Flash Firmware Version : 5.01.01
Updating Flash on HBA port(s) - QLE8142. Please wait...
Updating Adapter flash NIC Boot Code...
Updating Adapter flash NIC MPI FW...
Updating Adapter flash FC Boot Code/FW...
Updating Adapter flash uncompressed FW...
Updating Adapter flash FC VPD...
Updating Adapter flash NIC VPD...
Flash update complete. Changes have been saved to both ports of
this HBA.
Save Flash (Per Adapter Port)
(Command Line Option -b and Reserved Word “save”)
10: Utilities 2: Save Flash
When you select this option, SANsurfer FC/CNA HBA CLI opens the Save Flash
Menu, where you select an adapter port and then enter a file name to save.
Update HBA Parameters (Per Adapter Port or All HBAs)
(Command Line Option -r)
10: Utilities 3: Update HBA Parameters
When you select Update HBA Parameters, you are prompted to select either one
of your adapter port instances or All HBAs to update. SANsurfer FC/CNA HBA
CLI then shows the following warning message:
NOTE:
The Flash save-to-file option is not supported on QLE/QMI81xx adapters.