Q-Logic FC0E Network Card User Manual


 
4–Non-Interactive Commands
Command Summary
SN0054614-00 K 4-33
Where:
Table 4-13 defines the link status parameter names, aliases, and values.
-m
(View, Enable, or Disable LUNs)
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameter (see Table 4-13)
param alias = Alias of the parameter (see Table 4-13)
param value = New value of the parameter (see Table 4-13)
Table 4-13. Link Status Parameters
Description Name Alias Value
Sets link-status retrieval period AutoPoll AP
0–256
a
cycles
a
When the AutoPoll parameter is 0, the link status is retrieved automatically until the user aborts the
operation. When the AutoPoll parameter is in the range of 1–256, the link status is retrieved for the
number of cycles specified by this value.
Sets link-status retrieval polling interval PollRate SR 5–30 seconds
Save link status to CVS log file LogToFile LF Log file name
Table Notes
NOTE:
If the current driver setting is Bind by Port ID, this option is not available.
Under Solaris, if you use the driver from the OS installation CDs (QLC
driver), this feature is disabled.
Under Linux, if you use the IOCTL or sysfs (inbox) driver, this feature is
disabled.
Under Solaris, the QLA adapter driver supports a maximum of 256
LUNs.
Under Solaris, the QLC adapter driver supports a maximum of 16K
LUNs.
You must persistently bind the targets before configuring selective LUNs,
(link).