Filter
Top Products
4–Non-Interactive Commands
Command Summary
4-46 SN0054614-00 K
To show the target information for a specific target on a specific adapter, type:
-t (<hba instance> | <hba wwpn>) (<target wwpn> | <target port
id>)
iiDMA (intelligent interleaved direct memory access) settings include:
—targets | –t applies to all targets.
<speed> indicates the supported intelligent interleave factor: 1, 2, 4, or 8
Gbps.
-tb
(Target Beacon On/Off)
To start or stop flashing a target’s LED, type:
# scli -tb (<hba instance> | <hba wwpn>) (<target wwpn>)
(<0 | ON> | <1 | PRESET>)
-tp
(Display Host Topology)
Use the -tp option to show the topology configuration of the host:
# scli -tp | topology
Under Linux, this feature is disabled if you are using the IOCTL or sysfs (inbox)
driver.
“Host Topology (Command Line Option -tp)” on page 4-3 covers this command.
-u
(Firmware Area Update/Save)
Use the -u option to update the firmware preload area of the adapter from a
DAT file or to save the current firmware preload area of the adapter to a DAT file.
To update the adapter firmware preload table, enter the following command:
# scli -u ( <hba instance> | <hba wwpn> ) <file name>
NOTE:
The <0 | ON> option flashes the LED until interrupted. The <1 |
PRESET> option flashes the LED 12 times.
This feature is supported only on JBOD (“just a bunch of disks”) devices.
NOTE:
This option is available only for 8Gb adapters.