Filter
Top Products
4–Non-Interactive Commands
Command Summary
SN0054614-00 K 4-39
The following example is a typical SANsurfer FC/CNA HBA CLI output showing all
targets currently bound to an adapter:
--------------------------------------------------------------------------
HBA 0: QLA2462 Port 1 WWPN xx-xx-xx-xx-xx-xx-xx-xx Port ID 11-06-EF
--------------------------------------------------------------------------
Bind Type Device Node Name Device Port Name Port ID ID
---- ---- ---------------- ---------------- ------- --
No Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E1
Yes Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E2 0
Yes Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-
xx-xx-xx-xx-xx 10-02-E4 1
Yes Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E8 2
Press <Enter> to continue:
To bind a selected target to a specific adapter, type:
# scli -p (<hba instance> | <hba wwpn>) (<target wwnn> <target
wwpn> <target port id> <target id>)
Where:
To bind multiple targets with a single command, repeat the following group:
<target wwnn> <target wwpn> <target port id> <target id>
To bind all targets on a specific adapter or to bind all targets on all adapters, type:
# scli -p (<hba instance> | <hba wwpn> | all) bind all
Where:
To unbind a specific target, type:
# scli -p (<hba instance> | <hba wwpn>) (remove <target wwnn>
| unbind <target wwnn>)
hba instance = Adapter number (use -g command to find)
hba wwnn = Word wide node name of the adapter
hba wwpn = World wide port name of the adapter
target wwnn = World wide node name of the target
target wwpn = World wide port name of the target
target port id = Port ID of the target
target id = ID to which the target is bound
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter