Filter
Top Products
3–Interactive Commands
Utilities Menu
SN0054614-00 K 3-69
HPQ (HP-specific settings—2Gb HP adapters)
IBM (IBM-specific settings)
QLGC (QLogic-specific settings)
SUN (Sun-specific settings)
Select one of the templates to apply it immediately to the adapter port instance (or
All HBAs.) The following is returned:
Updating HBA Parameters on HBA instance n - QLA2nnn. Please
wait...
HBA Parameters update complete. Changes have been saved and
applied to the HBA instance n.
Update Driver
(Command Line Option -d)
10: Utilities n: Update Driver
The Update Driver option is available on Windows systems only. When you
select Update Driver from the Utilities menu, SANsurfer FC/CNA HBA CLI
prompts you to select an adapter port, and then enter a file name (INF, ZIP, or
EXE) with which to update the driver for that port.
Update Firmware Preload Table
10: Utilities n: Update Firmware Preload Table
The preload table is basically a list of register addresses and data values. The
only flexibility is provided by means of flags that indicate which function and for
what type of reset the entry applies. The ROM code simply walks the list and
loads the registers with the values, as permitted by the flags. The set of registers
include MSI-X, Member, and so on.
The Update Firmware Preload Table option is supported only for 8Gb adapters.
When you select this option from the Utilities menu, SANsurfer FC/CNA HBA CLI
prompts you to select either an 8Gb adapter or All HBAs to update.
For example:
NOTE:
FCoE converged network adapters require a FCoE-specific driver.
NOTE:
The Update Firmware Preload Table option does not apply to Linux Inbox
drivers.