Filter
Top Products
Switch 09 - Various
Digit Purpose
0, 1
Memory lock Digit 1 Digit 0 Setting
(Feature Expander Required) X 0 Off*
0 1 Messages from senders whose
RTI/CSI are programmed are not
printed unless you enter the memory
lock ID.
1 1 Messages from senders whose
RTI/CSI are not programmed are not
printed unless you enter the memory
lock ID.
2 to 7 Do not change these settings.
Switch 10 Various
Digit Purpose
0 Reverse order printing (Feature Expander Required) 0: Off* 1: On
1 to 6 Do not change these settings
7
Halftone mode 0: Standard Mode*
1: Speed Mode
Switch 11 Various
Digit Purpose
0 to 5 Do not change these settings.
6
Printing the received message when it is acted as a forwarding station.
0: Off 1: On*
7 Polling standby duration 0: Once* 1: Keep
Switch 12 Various
Digit Purpose
0 and 1 Do not change these settings.
2
Toner saving mode 0: Off* 1: On
Note:
If on, contrast will be set to "Normal" automatically, preserving image quality.
This is available when receiving fax messages and printing reports, but not for
copying or printing from a PC.
Further, messages sent to you in halftone mode will automatically turn off toner
saving to insure a clear image.
To make sure that the fax quality is acceptable with toner saving on, print a few
reports. (See page 172 ).
(Note: If the sender is using a machine made by another manufacturer, toner saving
will stay on and this could lower image quality.)
3 and 4
Density of the printing image Digit 4 Digit 3 Setting Digit 4 Digit 3 Setting
0 0 Normal * 0 1 Lighten
1 0 Darken 1 1 Do not use
these settings
5 to 7 Do not change these settings.
HOW TO USE THIS MANUAL
14