Filter
Top Products
Switching Memory Lock On/Off
Before you can use Memory Lock, you have to switch it on using Function 62.
After you switch Memory Lock on, will appear on the display
when the machine is in standby mode.
NOTE: If you switch Memory Lock on, Forwarding will be automatically disabled.
1. Function 6 2 2 2 2 6 2 and Yes.
2. Scroll through the features with until the
screen is as shown opposite.
3. Yes.
4. Change the on/off setting by pressing
or .
5. Finsh: Yes and Function.
If you wish, you can prevent unidentified senders from sending you messages while Memory
Lock is on. See page 78.
Programming Special Terminals for Memory Lock
If you would like to receive information from only select locations into Memory
Lock, you can program the RTI codes or CSI codes of those locations. A terminal
sending an incoming message always identifies itself to your terminal. The
identification consists of an RTI or a CSI. When you specify the senders for
Memory Lock, you must program a list of these codes. Program the list using
Function 81 called "Special Terminal" (see page 101).
Selecting Which Messages to Lock in Memory
You have to select either to:
❐ Only Lock messages from Special Terminals.
❐ Lock all messages except those from Special Terminals.
1. Function 6 2 2 2 2 6 3 and Yes.
At this time, you can print a User Pa-
rameter List if you press and Start.
2. Yes.
RECEPTION ADVANCED FEATURES
76