Filter
Top Products
Switch 09 - Various
Digit Purpose
0, 1
Memory lock Digit 1 Digit 0 Setting
(Feature Expander Required) X 0 Off*
0 1 Only Lock messages from senders
whose RTI/CSI’s are programmed.
1 1 Lock all messages except those from
senders whose RTI/CSI’s are
programmed.
2 to 7 Do not change these settings.
Switch 10 Various
Digit Purpose
0 Reverse order printing 0: Off* 1: On
1 Two in One (Into 1) 0: Off* 1: On
2 to 6 Do not change these settings
7
Halftone mode 0: Standard Mode*
1: Speed Mode
Switch 11 Various
Digit Purpose
0 to 5 Do not change these settings.
6
Printing the received message when it is acted as a forwarding station.
0: Off 1: On*
7 Polling standby duration 0: Once* 1: Keep
Switch 12 Various
Digit Purpose
0 and 1 Do not change these settings.
2
Toner saving mode 0: Off* 1: On
Note:
3 and 4
Density of the printing image
Digit 4 Digit 3 Setting Digit 4 Digit 3 Setting
0 0 Normal * 0 1 Lighten
1 0 Darken 1 1 Do not use
this setting
5 to 7 Do not change these settings.
Locked messages are
printed when you enter the
Memory Lock ID.
If on, contrast will be set to "Normal" automatically, preserving image quality.
This is available when receiving fax messages and printing reports, but not
for copying or printing from a PC.
Further, messages sent to you in halftone mode will automatically turn off
toner saving to ensure a clear image.
To make sure that the fax quality is acceptable with toner saving on, print a
few reports (See page 137 ).
(Note: If the sender is using a machine made by another manufacturer, toner
saving will stay on and this could lower image quality.)
TECHNICAL
REFERENCE
TECHNICAL REFERENCE ON/OFF SWITCHES AND USER PARAMETERS
189