Filter
Top Products
To switch Restricted Access On or Off, do the following:
If you wish to switch Restricted Access on or off, do the following procedure. (See
page 11 if you need more information about the User Parameter settings
adjustment procedure).
1. Function 6 2 2 2 2 6 3 and Yes.
2. Yes.
3. The settings for switch 00 are now shown
on the bottom line of the display.
4. Press until the settings for switch05 are
shown.
The setting that you need to change is
digit 4 and 5.
Digit 4(Underlined)
Digit 5(Double Underlined)
Digit Purpose
4
5
Restricted Access Digit 4 Digit 5 Setting Digit 4 Digit 5 Setting
0 0 Off 1 X Do not use this
1 0 On
5. If you wish to change the setting, press 4 or 5 on the ten key pad.
6. Finish: Yes and Function.
Operating the Machine with Restricted Access Switched On
If you have switched Restricted Access on, the display is as shown below when
the machine is in standby mode.
Before you can use the machine, you must enter your personal code that you
have already registered in the machine. See page 107 for how to store Personal
Codes.
1. Either
Enter your personal code.
Example: 7 3 6 2 from the ten key pad.
2. Press Yes. After a second, the normal standby display will appear, and you can
use the machine. If the normal standby display does not appear, you entered
a personal code that is not stored in the machine.
If you decide that you do not wish to use the machine now, you should return the
machine to Restricted Access standby mode. To do this, either:
Insert a page into the document feeder and remove it immediately.
Press Function twice.
ADVANCED
FEATURES
ADVANCED FEATURES TRANSMISSION
111