Filter
Top Products
AX500 Quick Start
14 AX500 Motor Controller User’s Manual Version 1.9b. June 1, 2007
The front side contains the 15-pin connector to the R/C radio, joystick or microcomputer, as
well as connections to optional switches and sensors.
At the back of the controller (shown in the figure below) are located all the that must be
connected to the batteries and the motors.
Status LED
FIGURE 1. AX500 Controller Front View
Connector to Receiver/
Controls and sensors
VMot
Motor 2 Motor 1
M2+ M1- M1+ VMotM2- 3 x Gnd
VCon
FIGURE 2. AX500 Controller Rear View
Power Must be con-
nected to VCon and
VMot for the controller
to operate
Note:
Both VMot terminals are
connected to each other
in the board and must be
wired to the same volt-
age.