Filter
Top Products
3
1600XP Series Installation and Operation Manual
2. Equipment Warning Labels
The following pages show examples of warning labels that may be attached to either the interior or ex-
terior of the UPS. Do not remove or cover any of the labels. If the labels are damaged or if additional
labels are required, contact your equipment representative for additional labels.
These labels are placed to provide useful information or to indicate an imminently hazardous situation
that may result in severe equipment/property damage, serious injury, or loss of life if instructions are
not followed.
P/N 63094 – External warning sign.
• Unit contains potentially dangerous voltages.
• Read the instruction manual before operating.
• There are no user serviceable parts inside.
Refer service to qualied personnel.
• Do not open the cover while power is applied,
or within ve minutes after removal of power.
• Potentially hazardous leakage current may
exist. Ensure the grounding is connected
before connecting the utility power.
P/N 48518 – Battery terminals can deliver
dangerous electrical shock. Service by
qualied service representatives only.
WARNING
This unit contains sealed lead acid batteries.
Lack of preventative maintenance could result
in batteries exploding and emitting gasses and/or
flame. Annual preventative maintenance must be
performed by an authorized, trained technician.
WARNING
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
49455 SHEET
CAUTION/
ATTEN TIO N
Do not disconnect
while unit is
operating
on battery power.
Nes pas debrancher
sous charge.
48524 SHEET
Risk of electric shock. Do not remove cover.
. Refer servicing to qualified service personnel.
NO USER SERVICEABLE PARTS
INSIDE
To reduce the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants.
En cas utilisation en atmosphere controlee. Consulter la notice technique.
Note: Service personnel only.
Hazardous live parts inside the UPS are energized from the battery supply
even when the input AC power is disconnected.
Capacitors store hazardous energy. Do not remove cover until 5 minutes
after disconnecting all sources of supply.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually between service periods. The batteries should be
replaced every three years after the last servicing, the date of which is
written on the ID plate located on the rear side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do not insert ba tte ry trays with the power off !
Th is uni t is desi gned for ho t changeable batteries!
When installing batteries, the UPS must be in the
online or bypass mode. Contact Toshiba
International Corporation for further details.
6041 2
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do not touch uninsulated
battery terminals. Batteries should be serviced by
qualified service representative only. Miswiring of
battery could result in electrcal shock and/or fire.
Risque de choc electrique. Le circuit des batteries
nest pas esolede secteur. Les cosses des batteries
peuvent presenter une tension dangereuse part
rapport a la terre. Verifier avant de toucher.
DANGER
Battery fuse is always
live. Risk of ele ctrical
shock. Check fuse
voltage and disconnect
external batteries
before changing fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS
HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 60381
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO1
EPO2
REMO TE
REMOTE
1
L1
L2 G
X1 X2
208V
120V
120V
208/240V
OUTPUT
INPUT
N
X3
G
208V
USE COPPER 90 CONDUCTORS ONLY. REFER TO INSTRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 208V INPUT.
COM
2
3
4
5
6 7
8
11
12
13
240V
240V
REMO TE
JUMPER SELECTION
50802
P/N 49455 – UPS Batteries require an-
nual preventative maintenance. Failure to
perform regular maintenance could result in
batteries exploding, or emitting gasses or
ame.
WARNING
This unit contains sealed lead acid batteries.
Lack of preventative maintenance could result
in batteries exploding and emitting gasses and/or
flame. Annual preventative maintenance must be
performed by an authorized, trained technician.
WARNING
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
49455 SHEET
CAUTION/
ATTEN TIO N
Do not disconnect
while unit is
operating
on battery power.
Nes pas debrancher
sous charge.
48524 SHEET
Risk of electric shock. Do not remove cover.
. Refer servicing to qualified service personnel.
NO USER SERVICEABLE PARTS
INSIDE
To reduce the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants.
En cas utilisation en atmosphere controlee. Consulter la notice technique.
Note: Service personnel only.
Hazardous live parts inside the UPS are energized from the battery supply
even when the input AC power is disconnected.
Capacitors store hazardous energy. Do not remove cover until 5 minutes
after disconnecting all sources of supply.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually between service periods. The batteries should be
replaced every three years after the last servicing, the date of which is
written on the ID plate located on the rear side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do not insert ba tte ry trays with the power off !
Th is uni t is desi gned for ho t changeable batteries!
When installing batteries, the UPS must b e in the
on lin e or b ypass mode. Contact Toshiba
In tern ati onal Corporation for further details.
6041 2
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do not touch uninsulated
battery terminals. Batteries should be serviced by
qualified service representative only. Miswiring of
battery could result in electrcal shock and/or fire.
Risque de choc electrique. Le circuit des batteries
nest pas esolede secteur. Les cosses des batteries
peuvent presenter une tension dangereuse part
rapport a la terre. Verifier avant de toucher.
DANGER
Battery fuse is always
live. Risk of electrica l
shock. Check fuse
voltage and disconnect
external batteries
before changing fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS
HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 60381
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO1
EPO2
REMO TE
REMOTE
1
L1
L2 G
X1 X2
208V
120V
120V
208/240V
OUTPUT
INPUT
N
X3
G
208V
USE COPPER 90 CONDUCTORS ONLY. REFER TO INSTRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 208V INPUT.
COM
2
3
4
5
6 7
8
11
12
13
240V
240V
REMO TE
JUMPER SELECTION
50802
P/N 49455 – Replace Fuse only
with one of same type and range.
Incorrect fuse size may result in
equipment damage.
WARNING
This unit contains sealed lead acid batteries.
Lack of preventative maintenance could result
in batteries exploding and emitting gasses and/or
flame. Annual preventative maintenance must be
performed by an authorized, trained technician.
WARNING
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
49455 SHEET
CAUTION/
ATTEN TIO N
Do not disconnect
while unit is
operating
on battery power.
Nes pas debrancher
sous charge.
48524 SHEET
Risk of electric shock. Do not remove cover.
. Refer servicing to qualified service personnel.
NO USER SERVICEABLE PARTS
INSIDE
To reduce the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants.
En cas utilisation en atmosphere controlee. Consulter la notice technique.
Note: Service personnel only.
Hazardous live parts inside the UPS are energized from the battery supply
even when the input AC power is disconnected.
Capacitors store hazardous energy. Do not remove cover until 5 minutes
after disconnecting all sources of supply.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually between service periods. The batteries should be
replaced every three years after the last servicing, the date of which is
written on the ID plate located on the rear side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do not insert ba tte ry trays with the power off !
Th is uni t is desi gned for ho t changeable batteries!
When installing batteries, the UPS must be in the
online or bypass mode. Contact Toshiba
International Corporation for further details.
6041 2
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do not touch uninsulated
battery terminals. Batteries should be serviced by
qualified service representative only. Miswiring of
battery could result in electrcal shock and/or fire.
Risque de choc electrique. Le circuit des batteries
nest pas esolede secteur. Les cosses des batteries
peuvent presenter une tension dangereuse part
rapport a la terre. Verifier avant de toucher.
DANGER
Battery fuse is always
live. Risk of ele ctrical
shock. Check fuse
voltage and disconnect
external batteries
before changing fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS
HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 60381
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO1
EPO2
REMO TE
REMOTE
1
L1
L2 G
X1 X2
208V
120V
120V
208/240V
OUTPUT
INPUT
N
X3
G
208V
USE COPPER 90 CONDUCTORS ONLY. REFER TO INSTRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 208V INPUT.
COM
2
3
4
5
6 7
8
11
12
13
240V
240V
REMO TE
JUMPER SELECTION
50802