Filter
Top Products
2. SYSTEM MODE EO13-33003
2.1 Self-diagnostic Test
2- 6
NOTE: Print conditions:
Print speed: 4”/sec., Sensor: No sensor, Printing mode: Thermal transfer/Direct thermal
(*1)
, Media length: 220 mm,
Issue mode: Batch printing
(*1) Depends on the printing mode setting.
• Descriptions of the Maintenance Counter
# Item Count Condition Range
(1)
Total media distance
covered
0.0 to 3200.0 km
(2) Media distance
covered
Counts when the feed motor is driven to feed, print or issue media. (Counted
also during a reverse feed.) See NOTE 2.
Destination printed on the same line indicates one selected for a parameter
clear.
0.0 to 3200.0 km
(3) Print distance Counts while printing. (Reverse feed is not counted.) See NOTE 3. 0.0 to 200.0 km
(4) Cut count Counts every cut. See NOTE 4. 0 to 1000000 times
(5) Ribbon motor driving
time
Counts when the ribbon motor is driven to feed, print or issue media. (The
driving time is also counted during a reverse feed.) See NOTE 5.
0 to 2000 hours
(6) RS-232C hardware
error count
Counts when a parity, overrun or framing error occurs. See NOTE 6. 0 to 255 times
(7) System error count Counts when a system error occurs. 0 to 15 times
(8) Momentary power
failure count
Counts when a momentary power interruption occurs. 0 to 15 times
NOTES:
1. Item from (2) through (8) are initialized to “0” after RAM clear.
2. If the media distance covered is 50.0 cm or less, it is rounded down and no data is added to the memory at power off.
3. If the print distance is 5.5 m or less, it is rounded down and no data is added to the memory at power off.
4. If the count is 31 or less, it is rounded down and no data is added to the memory at power off.
5. If the driving time is 27 sec. or less, it is rounded down and no data is added to the memory at power off.
6. When a sent command results in an error, the same number as the data capacity of the command is counted by byte.
SOCKET PORT [OFF] [08000]
BASIC [OFF]
BASIC TRACE [OFF]
DHCP [OFF]
DHCP ID [FFFFFFFFFFFFFFFFFFFF]
[FFFFFFFFFFFF]
DHCP HOST NAME [ABCDEFGHIJKLMNOP]
RTC BATT. CHK [ON]
RTC RENEWAL [BATCH]
(49)
(50)
(51)
(52)
(53)
(54)
(55)
(56)
-------------------------------------------------------------------------------