Filter
Top Products
1. INTRODUCTION EO13-33003
1.1 Key Operation Flow
1- 1
1. INTRODUCTION
This document describes key operations using the keys and LCD display on the printer that you can operate
on a printer alone. Key operations are performed in the following four printer setting modes:
• Online mode where a pause, reset, automatic threshold setting, etc. are performed.
• Download mode where a firmware downloading is performed.
• System mode for service personnel where a self-diagnosis, printer parameter settings, RAM clear, IP
address setting etc. are performed.
• System mode for end user where a self-diagnosis, printer parameter settings, fine adjustment, etc.,
which are same functions as those in System mode for service personnel, are performed.
1.1 Key Operation Flow
Download mode
Power OFF
Feed gap sensor automatic threshold setting
Black mark sensor threshold setting
Turn the power on.
While holding down the [FEED] and [RESTART]
keys, turn the power on.
While holding down the
[FEED] and [PAUSE]
keys, turn the power on.
[FEED] key
[RESTART] key
Hold down the [PAUSE] key
for a few seconds.
Hold down the [RESTART] key
for a few seconds.
[FEED] key or [RESTART] key
[PAUSE] key
Online
Feeds one label.
Pause
• Self-test
• Parameter setting
• Fine adjustment
• Test print
• Sensor adjustment
• RAM clear
• IP Address setting
• Basic setting
• For factor
y
• Self-test
• Parameter setting
• Fine adjustment
•
Test
p
rint
While holding down the [FEED],
[RESTART], and [PAUSE] keys,
turn the power on.
• Reset
• Parameter Setting
• Fine adjustment
• Dump mode
• Expand mode (Basic expansion mode)
• Automatic calibration mode
• LAN Enable/Disable
• RTC Setting
System mode for end users
System mode for service personnel
Online mode