Filter
Top Products
2. SYSTEM MODE EO13-33003
2.2 Parameter Setting
2-18
2.2.4 Data Length Selection
This parameter is to choose a communication data length of the RS-232C interface.
7 bits is used when transmitting alphanumeric data only. 8 bits is used to when transmitting special
characters. Be sure to match a setting with a host computer.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a data length, press the [PAUSE] key.
2.2.5 Stop Bit Length Selection
This parameter is to choose a stop bit length of the RS-232C interface.
Be sure to match a setting with a host computer.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a stop bit, press the [PAUSE] key.
2.2.6 Parity Selection
This parameter is to choose the parity of the RS-232C interface.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the parity, press the [PAUSE] key.
DATA LENG. 8bits
DATA LENG. 7bits
DATA LENG. 8bits
[RESTART]
[FEED]
STOP BIT 1bit
STOP BIT 2bits
STOP BIT 1bit
[RESTART]
[FEED]
PARITY NONE
PARITY EVEN
PARITY ODD
[RESTART]
[FEED]
PARITY NONE