Filter
Top Products
2. SYSTEM MODE EO13-33003
2.2 Parameter Setting
2-26
NOTE: Difference between TYPE 1 and TYPE 2
TYPE1:
When a label end or ribbon error is detected, printing is immediately stopped. When the printing is restarted, first
the initial feed is performed, and then the printer starts printing from the unfinished label.
TYPE2:
When a label end is detected:
When a label end is detected in the middle of printing, the printer completes the half-finished label and stops
when the next label comes to the home position, displaying the error message “NO PAPER X”.
NOTES: 1. “X” indicates the number of remaining labels to be printed.
The number of remaining labels to be printed = Specified number of labels
−
The number of finished
labels including the label that caused the error
2. If a label end is detected while the specified last label is printed, the position of “X” will be blank.
When the printing is restarted, first an initial feed is performed, and then the printer starts printing
from the next label. When the printer has already completed printing the last label, it only performs
an initial feed. Then, it sends an End of Feed status and an End of Issue status if the status
response parameter is set to ON.
Example) Number of specified labels = 5, A label end is detected while the 3rd label is printed.
(1) After the 3rd label is printed completely, the printer stops, displaying “NO PAPER 2”.
(2) When printing is restarted, first an initial feed is performed, then the 4th and 5th labels are printed.
(3) All of 5 labels have been finished.
When a ribbon error is detected when the unfinished label length is 30 mm or more.
After printing for 20mm, the printer stops printing, displaying an error message “RIBBON ERROR X”.
NOTES: 1. “X” indicates the number of remaining labels to be printed.
The number of remaining labels to be printed = Specified number of labels
−
The number of finished
labels
−
1
2. If a ribbon error is detected while the specified last label is printed, the position of “X” will be blank.
When the printing is restarted, first an initial feed is performed, and then the printer starts printing
from the next label. When the printer has already completed printing the last label, it only performs
an initial feed.
Example) Specified number of labels = 5, A ribbon error is detected while the 3rd label is printed.
(1) After the 3rd label is printed for 20 mm, the printer stops, displaying “RIBBON ERROR 2”.
(2) When printing is restarted, first an initial feed is performed, then the 4th and 5th labels are printed.
(3) Only the 3rd label has not been printed completely.
When a ribbon error is detected when the unfinished label length is less than 30 mm.
The printer completes the current label and stops printing when the next label comes to the home position,
displaying the error message “RIBBON ERROR X”.
NOTES: 1. “X” indicates the number of remaining labels to be printed.
The number of remaining labels to be printed = Specified number of labels
−
The number of finished
labels including the label that caused the error
2. If a ribbon error is detected while the specified last label is printed, the position of “X” will be blank.
When the printing is restarted, first the initial feed is performed, and then the printer starts printing
from the next label. When the printer has already completed printing the last label, it only performs
an initial feed. Then, it sends an End of Feed status and an End of Issue status if the status
response parameter is set to ON.
Example) Specified number of labels = 5, A ribbon end is detected while the 3rd label is printed.
(1) After the 3rd label is printed completely, the printer stops, displaying “RIBBON ERROR 2”.
(2) When printing is restarted, first an initial feed is performed, then the 4th and 5th labels are printed.
(3) All of 5 labels have been finished.