Filter
Top Products
2. SYSTEM MODE EO13-33003
2.3 Printer Parameter Fine Adjustment
2-34
NOTES:
1. The fine adjustment value equals to the sum of the fine adjustment values set by the PC command and this
parameter. The maximum reverse feed amount fine adjustment value is +
9.9 mm. When the value reached
the maximum, the value remains unchanged even if the subsequent fine adjustment is performed.
2. There may be cases where a label is not returned to the home position depending on the print conditions,
even if a reverse feed amount is the same as a forward feed amount.
When an operation including a reverse feed (cut issue, strip issue for auto labeler, forward feed standby after
an issue) is performed using a sensor, a label/tag may not be returned to the home position resulting an error,
if the label pitch length is almost the same as the distance between the thermal print head and the paper
sensor. To prevent this problem, the reverse feed amount should be increased by performing the reverse
feed amount fine adjustment in the + direction.
2.3.4 X Coordinate Fine Adjustment
This parameter is to fine adjust the print position on X coordinate.
When “<3>ADJUST SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option. (Range: -99.9 mm to +99.9 mm)
[FEED] key: Pressing the [FEED] key one time causes a –0.1 mm change, up to –99.9 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +0.1 mm change, up to +99.9 mm.
After completing the fine adjustment, press the [PAUSE] key.
X ADJUST +5.0mm
[RESTART]
[FEED]
X ADJUST +99.9mm
X ADJUST +99.8mm
X ADJUST +0.0mm
X ADJUST -99.8mm
X ADJUST -99.9mm
X ADJUST -0.1mm
X ADJUST +0.1mm