Filter
Top Products
2. SYSTEM MODE EO13-33003
2.2 Parameter Setting
2-19
2.2.7 Flow Control Code Selection
This parameter is to choose a flow control code of the RS-232C interface.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a flow control code, press the [PAUSE] key.
NOTE: The following is the detailed descriptions for each transmission control code.
1) XON/XOFF AUTO
At the power on time, the printer outputs XON. At the power off time, the printer outputs XOFF.
2) XON+READY AUTO
At the power on time, the printer outputs XON. At the power off time, the printer outputs XOFF.
3) READY/BUSY
At the power on time, the DTR signal output from the printer turns to High level (READY). At the
power off time, the printer does not output XOFF.
4) ON/XOFF
At the power on time, the printer outputs XON. At the power off time, the printer does not output
XOFF.
5) READY/BUSY RTS
At the power on time, the RTS signal output from the printer turns to High level (READY). At the
power off time, the printer does not output XOFF.
2.2.8 LCD Language Selection
This parameter is to choose a language in which the LCD message is displayed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a language, press the [PAUSE] key.
XON+READY AUTO
[RESTART]
[FEED]
XON+READY AUTO
XON/XOFF AUTO
READY/BUSY
XON/XOFF
READY/BUSY RTS
XON/XOFF mode
XON/XOFF+READY/BUSY (DTR) mode
READY/BUSY (DTR) mode
XON/XOFF mode
RTS mode
LCD ENGLISH
[RESTART]
[FEED]
ENGLISH
ITALIAN
JAPANESE
SPANISH
DUTCH
FRENCH
GERMAN