- 19 -
• RS-232C transmission control
• XON/XOFF protocol: (No XON output when the power is on, no XOFF
output when the power is off)
• READY/BUSY (DTR) protocol: (No XON output when the power is on, no XOFF
output when the power is off)
• XON/XOFF + READY/BUSY (DTR) protocol:
(XON output when the power is on, XOFF output
when the power is off)
• XON/XOFF protocol: (XON output when the power is on, XOFF output
when the power is off)
• RTS protocol: (No XON output when the power is on, no XOFF
output when the power is off)
• Language for LCD messages
• ENGLISH
• GERMAN
• FRENCH
• DUTCH
• SPANISH
• JAPANESE
• ITALIAN
NOTE: When Japanese is selected, the character cords partially differ.
• Forward feed standby after an issue
• ON (Performed)
• OFF (Not performed)
NOTE: If the printer is in the idle state for 1 second or more after an issue is performed when
ON is selected, the printer automatically performs a 19-mm forward feed, then stops.
This setting is used to prevent curled labels from being entangled with the cutter or the
platen, or to cut labels manually.
• Type of control code
• Automatic selection (ESC, LF, NUL/{, |, })
• Manual selection (ESC, LF, NUL mode)
• Manual selection ( {, |, } mode)
• Any set code
• [FEED] key function
• FEED: Feeds one label.
• PRINT: Prints data of image buffer on one label.
• Kanji code selection
• TYPE1
• TYPE2
• Euro code (new currency symbol) setting
• 20H to FFH
• Automatic head broken dots check
• ON (When the power is turned on, the broken dots check is automatically performed.)
• OFF (When the power is turned on, the broken dots check is not automatically performed.)
