Filter
Top Products
2. SYSTEM MODE EO13-33003
2.3 Printer Parameter Fine Adjustment
2-36
2.3.5 Print Tone Fine Adjustment (Thermal Transfer/Thermal Direct Print)
This parameter is to fine adjust the Print Tone.
When “<3>ADJUST SET” appears, press the [PAUSE] key until the following display appears.
To fine adjust the print tone for thermal direct printing, press the [PAUSE] key again.
When the LCD display shows “TONE ADJ.<T>” or “TONE ADJ.<D>”, select a desired value with the
[FEED] or [RESTART] key. (Range: -10 to +10)
[FEED] key: Pressing the [FEED] key one time causes a –1 tone change, up to –10 tones.
[RESTART] key: Pressing the [RESTART] key one time causes a +1 tone change, up to +10 tones.
After completing the fine adjustment, press the [PAUSE] key.
NOTES: 1. The fine adjustment value equals to the sum of the fine adjustment values set by the PC command
and this parameter. The maximum print tone fine adjustment values for thermal transfer printing are
±10. Those for thermal direct printing are –10 and +6. (The values +7 to +10 are internally corrected
to +6.)
2. This is useful when print tone is required to be fine adjusted.
e.g.) When the ribbon is changed to different type.
TONE ADJ.<D> -2
TONE ADJ.<T> +3
Print Tone for thermal transfer printing
Print tone for thermal direct printing
[RESTART]
[FEED]
TONE ADJ<T>. +10
TONE ADJ<T>. +9
TONE ADJ<T>. +0
TONE ADJ<T>. -9
TONE ADJ<T>. -10
TONE ADJ<D>. +10
TONE ADJ<D>. +9
TONE ADJ<D>. +0
TONE ADJ<D>. -9
TONE ADJ<D>. -10
Darker
Lighter
Thermal Transfer Print Thermal Direct Print
Standard