Toshiba B-850 Printer User Manual


 
2. SYSTEM MODE EO13-33003
2.2 Parameter Setting
2-25
2.2.18 Expansion I/O Interface Type Selection
This parameter is to choose a type of the Expansion I/O interface operating mode.
This parameter should be set depending on the expansion I/O control specification of the device to be
connected via the expansion I/O interface. For details, refer to the External Equipment Interface
Specification.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting an Expansion I/O Interface type, press the [PAUSE] key.
2.2.19 Plug & Play Selection
This parameter is to choose whether to enable a Plug & Play function.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
NOTE: If the printer and the PC are connected by USB, plug & play will be automatically enabled, regardless of
the setting of this parameter.
After selecting a Plug & Play, press the [PAUSE] key.
2.2.20 Label End/Ribbon Error Selection
This parameter is to choose a printing process when a label end or ribbon error is detected. For details,
refer to NOTE on the following page.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Label End/Ribbon Error type, press the [PAUSE] key.
PLUG & PLAY OFF
PLUG & PLAY OFF
PLUG & PLAY ON
[RESTART]
[FEED]
Unavailable
Available
LBL/RBN END TYP1
LBL/RBN END TYP1
LBL/RBN END TYP2
[RESTART]
[FEED]
TYPE1: When a label end or ribbon error is detected in the
middle of printing, printing is immediately paused.
TYPE2: When a label end or ribbon error is detected in the
middle of printing, the printer prints the half-finished label as
far as possible, and stops when the next label is at the
home position.
EX.I/O TYPE1
EX.I/O TYPE1
EX.I/O TYPE2
[RESTART]
[FEED]
TYPE1: Standard mode
TYPE2: Inline mode