Filter
Top Products
2. SYSTEM MODE EO13-33003
2.2 Parameter Setting
2-24
2.2.16 Web Printer Function Selection
This parameter is to choose whether to use the printer as a web printer.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Web printer function, press the [PAUSE] key.
NOTE: When “WEB PRINTER ON” is selected, the status of the printer connected in a network can be checked
through the Web browser.
2.2.17 Input Prime Selection
This parameter is to choose whether to enable a reset operation when INIT signal is ON.
Normally, when the printer receives a reset request signal (nInit signal) from the host via Centronics
interface, the printer will be reset and turn to the idle state.
When the INPUT PRIME parameter is set to OFF, the printer is reset but does not turn to idle.
When this parameter is set to ON, the host sends an INIT signal and the printer turns to idle each time the
printer is turned on. If you would like to avoid this processing, set this parameter to OFF.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Input Prime, press the [PAUSE] key.
INPUT PRIME OFF
INPUT PRIME OFF
INPUT PRIME ON
[RESTART]
[FEED]
Unavailable
Available
WEB PRINTER OFF
WEB PRINTER OFF
WEB PRINTER ON
[RESTART]
[FEED]
Unavailable
Available