Filter
Top Products
2. SYSTEM MODE EO13-33003
2.2 Parameter Setting
2-20
2.2.9 Auto Forward Wait Selection
This parameter is to choose whether to activate the Auto Forward Wait function or not.
This function, used in the cut mode, automatically feeds the media forward for about 19 mm if there is more
than 1-second idle time after printing, to prevent the top edge of the media from curling.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
When ON is selected, pressing the [PAUSE] key will result that the LCD Message Display shows the stop
position fine adjustment value setting screen.
[FEED] key: Pressing the [FEED] key one time causes a –0.1 mm change, up to –5.0 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +0.1 mm change, up to +5.0 mm.
After selecting an auto forward wait, press the [PAUSE] key.
NOTES: 1. If the printer is not used for a few days, the top edge of the media may become curly, which may
cause a paper jam. The Auto Forward Wait Function prevents this problem since the media feed
amount is increased so that the media stops past the platen.
2. When the Stop Position Fine Adjustment Value is set in + direction, the media will stop past the
media outlet.
When the value is set in – direction, the media will stop inside the media outlet.
3. This setting will be useful to fine adjust the cut position of labels.
FORWARD WAIT OFF
[RESTART]
[FEED]
FORWARD WAIT OFF
Not activated
FORWARD WAIT ON
Activated
POSITION +5.0mm
[RESTART]
[FEED]
POSITION -5.0mm
POSITION +0.0mm
POSITION +0.0mm