Filter
Top Products
2. SYSTEM MODE EO13-33003
2.4 Test Print
2-41
Print Speed Setting
Select a print speed for the test print between 4”/sec. and 2”/sec.
After selecting a print speed, press the [PAUSE] key to go to Sensor Type Selection.
Sensor Type Selection
Select a sensor type among “TRANS” (Feed Gap Sensor), “REFLECT” (Lower Black Mark Sensor)
and “NONE”.
After selecting a sensor type, press the [PAUSE] key to go to Printing Mode Selection.
NOTE: Select a sensor type which is proper for the media being used. Basically, the Reflective Sensor
(Black Mark Sensor) is for tag paper, and the Transmissive Sensor (Feed Gap Sensor) is for label.
Printing Mode Selection
Select a printing mode for the test print between “TRANSFR” (Thermal transfer) and “DIRECT”
(Thermal direct).
After selecting a printing mode, press the [PAUSE] key to go to Issue Mode Selection.
NOTE: Select a printing mode which is proper for the operating conditions. Basically, the Thermal
Transfer is for the use of ribbon, and the Thermal Direct is for the use of thermal paper.
SENSOR NONE
SENSOR REFLECT.
[RESTART]
[FEED]
SENSOR TRANS.
None
Lower Black Mark Sensor
SENSOR TRANS.
Feed Gap Sensor
PRT TYPE TRANSFR
PRT TYPE TRANSFR
PRT TYPE DIRECT
Thermal Transfer
Thermal Direct
PRINT SPEED 4”/s
PRINT SPEED 4”/s
PRINT SPEED 2”/s
[RESTART]
[FEED]
[RESTART]
[FEED]