Filter
Top Products
2. SYSTEM MODE EO13-33003
2.2 Parameter Setting
2-21
2.2.10 Control Code Selection
This parameter is to choose a Control Code.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
NOTES: 1. This parameter is used to select the Control Code for the communication between the printer and
the host computer.
2. Selecting “Manual” enables you to set the control code.
When “CODE MANUAL” is selected and the [PAUSE] key is pressed, the LCD display will show the setting
screen of CONTROL CODE1 to CONTROL CODE3 as follows.
NOTES: 1. Pressing the [FEED] or [RESTART] key causes 1-byte change in the Control Code value.
2. You cannot specify the same control code with the one used for the commands.
3. You cannot use the specified Control Code for the data of the Data Command or Display Command.
After setting the control code for Control Code 1, press the [PAUSE] key to show the CONTROL CODE2
screen. In a same manner, press the [PAUSE] key after setting the control code for Control Code 2 to
display the CONTROL CODE3 screen.
Press the [PAUSE] key after setting the control code for Control Code 3.
CONTROL CODE1 1B
[RESTART]
[FEED]
CONTROL CODE1 FF
CONTROL CODE1 FE
CONTROL CODE1 01
CONTROL CODE1 00
CONTROL CODE1 FD
CONTROL CODE1 02
CODE AUTO
CODE ESC,LF,NUL
[RESTART]
[FEED]
CODE{|}
CODE AUTO
CODE MANUAL
Automatic selection
Manual selection
Manual selection
Control codes should be specified.
CONTROL CODE1
CONTROL CODE2
CONTROL CODE3
[PAUSE]
[PAUSE]