Filter
Top Products
3. ON LINE MODE EO13-33003
3. ON LINE MODE
3- 2
LCD message and LED indication
Symbols in the message
1: : The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: ###: Flash memory card remaining memory for PC save area 0 to 3072 (in K bytes)
4: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3072 (in K bytes)
LED Indication
No. LCD Message
POWER
ON
LINE
ERROR
Printer Status
Restoration
by
RESTART
key Yes/No
Acceptance of
Status Reques
t
Reset
Command
Yes/No
ON LINE z
In online mode
----- Yes
1
ON LINE
~ z
In online mode (The printer in
communication)
----- Yes
2 HEAD OPEN z z
The print head block is opened in online
mode.
----- Yes
3 PAUSE **** z z
The printer is paused.
Yes Yes
4 COMMS ERROR z
A parity, overrun, or framing error has
occurred during communication through
the RS-232C.
Yes Yes
5 PAPER JAM **** z
The media is jammed during paper feed.
Yes Yes
6 CUTTER ERROR**** z
A problem has occurred with the cutter
module.
Yes Yes
7 NO PAPER **** z
The media has run out, or the media is
not loaded on the supply holder properly.
Yes Yes
8 RIBBON ERROR**** z
The ribbon has run out, or has been torn.
A problem has occurred with the sensor
that determines the torque for the ribbon
motor.
Yes Yes
9 HEAD OPEN **** z
Feed or printing was attempted with the
print head block open.
Yes Yes
10 HEAD ERROR z
There is a problem with the print head.
Yes Yes
11 EXCESS HEAD TEMP z
The print head is overheated.
No Yes
12 SAVING ####&&&& z
In writable character or PC command
save mode
----- Yes
13 FLASH WRITE ERR. z
An error has occurred while writing to
flash memory.
No Yes
14 FORMAT ERROR z
An error has occurred in formatting the
flash memory.
No Yes
15 FLASH CARD FULL z
Data cannot be stored because the flash
memory..
No Yes
16 POWER FAILURE z
A power failure has occurred.
No No
17 MEM. INTIAL…
z z
A flash memory card is being initialised.
----- -----
18 EEPROM ERROR z
Data cannot be read from/written to a
backup EEPROM properly.
No No