Filter
Top Products
3. ON LINE MODE EO13-33003
3.6 LAN Enable/Disable Setting
3-10
9. When the cutter is installed and a previous issue was performed in cut issue mode, paper is cut and ejected
after automatic calibration completes.
10. When the automatic calibration is in operation, paper does not stop at a stop position of the strip issue.
11. An automatic forward feed is not performed immediately after an automatic calibration, even if the auto forward
wait parameter is set to ON.
3.6 LAN Enable/Disable Setting
Whether to enable the LAN or not and whether to enable Simple Network Management Protocol (SNMP) or
not are chosen by this menu.
How to Enable/Disable the LAN
[PAUSE]
<1>RESET
ON LINE
Press and hold the [RESTART]
key for 3 seconds or longer.
PAUSE 52
Press the [RESTART] key.
Press the [PAUSE] key to stop printing.
The number of remaining print count
NOTE: When the [PAUSE] key is pressed during printing, the number o
f
remaining print count is displayed.
<7>LAN
ON SNMP ON
[PAUSE]
Press the [PAUSE] key to enter the LAN Enable/disable setting menu.
Choose one of the following using the [FEED] or [RESTART] key.
• ON SNMP ON: LAN and SNMP are enabled.
• ON SNMP OFF: LAN is enabled, but SNMP is disabled.
• OFF: LAN is disabled.
<7>LAN
[PAUSE]
[FEED] or [RESTART]