Filter
Top Products
EO13-33003
TABLE OF CONTENTS
Page
1. INTRODUCTION-----------------------------------------------------------------------------------------------------1- 1
1.1 Key Operation Flow ----------------------------------------------------------------------------------------------1- 1
1.2 Operation Panel ---------------------------------------------------------------------------------------------------1- 2
2. SYSTEM MODE -----------------------------------------------------------------------------------------------------2- 1
2.1 Self-diagnostic Test----------------------------------------------------------------------------------------------2- 3
2.1.1 Printing Mode Selection----------------------------------------------------------------------------------------- 2- 4
2.1.2 Dispensing Mode Selection ------------------------------------------------------------------------------------ 2- 4
2.1.3 Maintenance Counter/Parameter Settings Printing Out ------------------------------------------------- 2- 5
2.1.4 Self-Diagnostic Test and Result Print Out ------------------------------------------------------------------ 2- 9
2.1.5 Print Head Element Check ------------------------------------------------------------------------------------ 2-14
2.2 Parameter Setting------------------------------------------------------------------------------------------------2-15
2.2.1 Character Code Selection ------------------------------------------------------------------------------------- 2-16
2.2.2 Character Zero Selection -------------------------------------------------------------------------------------- 2-17
2.2.3 Baud Rate Selection -------------------------------------------------------------------------------------------- 2-17
2.2.4 Data Length Selection------------------------------------------------------------------------------------------ 2-18
2.2.5 Stop Bit Length Selection-------------------------------------------------------------------------------------- 2-18
2.2.6 Parity Selection--------------------------------------------------------------------------------------------------- 2-18
2.2.7 Flow Control Code Selection---------------------------------------------------------------------------------- 2-19
2.2.8 LCD Language Selection -------------------------------------------------------------------------------------- 2-19
2.2.9 Auto Forward Wait Selection---------------------------------------------------------------------------------- 2-20
2.2.10 Control Code Selection----------------------------------------------------------------------------------------- 2-21
2.2.11 FEED Key Function Selection -------------------------------------------------------------------------------- 2-22
2.2.12 KANJI Code Selection------------------------------------------------------------------------------------------ 2-22
2.2.13 EURO Code Selection------------------------------------------------------------------------------------------ 2-22
2.2.14 Auto Print Head Check Selection ---------------------------------------------------------------------------- 2-23
2.2.15 Centronics Interface ACK/BUSY Timing Selection------------------------------------------------------ 2-23
2.2.16 Web Printer Function Selection ------------------------------------------------------------------------------ 2-24
2.2.17 Input Prime Selection------------------------------------------------------------------------------------------- 2-24
2.2.18 Expansion I/O Interface Type Selection-------------------------------------------------------------------- 2-25
2.2.19 Plug & Play Selection------------------------------------------------------------------------------------------- 2-25
2.2.20 Label End/Ribbon Error Selection --------------------------------------------------------------------------- 2-25
2.2.21 Maxi Code Specification Selection -------------------------------------------------------------------------- 2-27
2.3 Printer Parameter Fine Adjustment ----------------------------------------------------------------- 2-28
2.3.1 Feed Amount Fine Adjustment ------------------------------------------------------------------------------- 2-30
2.3.2 Cut Position (or Stop Position of the Strip Issue) Fine Adjustment---------------------------------- 2-31
2.3.3 Reverse Feed Amount Fine Adjustment ------------------------------------------------------------------- 2-33
2.3.4 X Coordinate Fine Adjustment-------------------------------------------------------------------------------- 2-34
2.3.5 Print Tone Fine Adjustment (Thermal Transfer/Thermal Direct Print) ------------------------------ 2-36
2.3.6 Ribbon Motor Voltage Fine Adjustment (Feed/Take-up Motor) -------------------------------------- 2-37
2.3.7 Threshold Manual Fine Adjustment (Black Mark/Feed Gap Sensor) ------------------------------- 2-38