Filter
Top Products
2. SYSTEM MODE EO13-33003
2.4 Test Print
2-40
How to Enter Test Print Mode
While pressing the [FEED] and [PAUSE] keys at the same time, turn on the printer. Hold both keys until
the “<1>DIAG. Vx.x” Message appears.
Press the [FEED] key 3 times.
The Test Print is ready to be performed.
NOTES: 1. When pressing the [FEED] and [RESTART] keys at the same time in the Test Print menu, the
message returns to “<4>TEST PRINT”.
2. If holding the [FEED] or [RESTART] key for 0.5 seconds or longer in the Test Print menu, the key is
entered continuously.
3. The fine adjustment parameters are effective for the Test Print. (except for X Coordinate Fine
Adjustment.)
4. If any error occurs, an error message appears, and the printer stops printing. After clearing the
errors, press the [PAUSE] key to return to the System Mode menu. The printer does not restart
printing automatically.
5. A changed parameter becomes enabled by pressing the [PAUSE] key.
6. A label size greater than the image buffer length cannot be designated. If designated, the printer
prints in the image buffer, or the printer stops because of an error.
2.4.1 Specifying the Print Condition for the Test Print
The print conditions for the Test Print should be specified before printing.
When “<4>TEST PRINT” appears, press the [PAUSE] key.
To set the print conditions, press the [PAUSE] key.
Issue Count Setting
Select an issue count from a range of 1 to 5000.
After selecting an issue count, press the [PAUSE] key to go to Print Speed Setting.
PRINT CONDITION
<1>DIAG. Vx.x
<4>TEST PRINT
[RESTART]
[FEED]
ISSUE COUNT 5000
ISSUE COUNT 1000
ISSUE COUNT 500
ISSUE COUNT 100
ISSUE COUNT 50
ISSUE COUNT 10
ISSUE COUNT 5
ISSUE COUNT 3
ISSUE COUNT 1
ISSUE COUNT 1