Filter
Top Products
4 Replacement Procedures 4.10 Display Assembly
4.10 Display Assembly
Removing the Display Assembly
To remove the display assembly, first remove the battery and the wireless LAN module (or
simply disconnect its aerial cables first), then follow the steps below.
NOTE: If you have a wireless LAN card installed, you will have to disconnect the wireless
LAN connector wire before removing the display assembly. See section 4-7 for details.
1. Insert a thin tool into the hole on the strip cover and slide it to the right. The strip cover
will pop up allowing you to remove it.
Figure 4-39 Removing the strip cover
2. Remove two M2.5×5 black screws and slide the joint covers outwards and upward to
remove them. Note that you’ll have to push the display back until it rests at a 135° angle
in order to get the joint covers out completely
Figure 4-40 Removing the joint covers
3. Remove the keyboard as described in section 4-6, Removing the Keyboard.
4-26 Satellite A30 Series Maintenance Manual