Filter
Top Products
4 Replacement Procedures 4.14 Fan
5. Disconnect the fan power cables.
Figure 4-62 Disconnecting the fan power cables
6. Remove the fan.
Figure 4-63 Removing the fan
Installing the Fan
To install the fan, follow the steps below.
1. Seat the fan on the system board.
2. Secure it with two M2×5 silver screws.
3. Secure the Northbridge heat sink cover, which also holds the fan place. To do so, you
must tighten 3 embedded screws.
4. Connect the fan power cables to the system board.
4-38 Satellite A30 Series Maintenance Manual