Filter
Top Products
2 Troubleshooting Procedures 2.11 DVD-ROM and Multi-Drive Troubleshooting
Procedure 5 Connection check and replacement check
The DVD-ROM or multi-drive connects to the system board. The drive may be disconnected, or
the drive or system board may be damaged. Disassemble the computer following the steps
described in Chapter 4, Replacement Procedures, and perform the following checks:
Check 1 Make sure the drive is firmly connected to the system board. If the connection is
good and there is still an error, go to Check 2.
Check 2 The drive or drive cable may be defective or damaged. Replace each with a new one
following the steps in Chapter 4, Replacement Procedures. If the drive is still not
functioning properly, perform Check 3.
Check 3 The system board may be damaged. Replace it with new one following the
instructions in Chapter 4, Replacement Procedures.
2-30 Satellite A30 Series Maintenance Manual