Filter
Top Products
3.2 Executing the Diagnostic Test 3 Test and Diagnostic Operation Handbook
3.2 Executing the Diagnostic Test
Toshiba MS-DOS is required to run the DIAGNOSTICS PROGRAM. To start the
DIAGNOSTIC PROGRAM, follow these steps:
1. Insert the diagnostics diskette #1 in the floppy disk drive and turn on the computer. (The
diagnostics diskette contains the MS-DOS boot files.) And then follow the instructions to
swap with the diagnostics diskette #2 for T&D program installed in RAM.
NOTE: To execute the CD test, make sure the CD is installed in the CD/DVD-ROM
drive.
The T&D Program can run by single test item when you press the corresponding letter of
The test list is as follows:
A. CONFIG CHECK TEST
ST
SYCARD TEST
CHARGE TEST
ST
ST
EST
a test item, or run two or more test items what you like if you choose them with “Arrow
cursors” and “Space Bar” – You can also set a test loop by pressing the “Enter” button. It
will ask you if you want to copy the test log file to diskette as reference when the tests
finish.
B. DMI CHECK TEST
C. PIO LOOPBACK TE
D. RTC Test
E. 32-BIT FOR
F. SPEAKER AUDIO TEST
G. FAN ON/OFF TEST
H. MODEM TEST
I. MAIN BATTERY
J. FDD TEST
K. CD-ROM TE
L. KEYBOARD TE
M. MOUSE (PAD) TEST
N. LCD PIXELS MODE T
O. LID SWITCH TEST
P. HDD R/W TEST
Q. LAN TEST
Satellite A30 Series Maintenance Manual 3-3