Filter
Top Products
Page 11-76287 ULTRA COMPATIBILITY
24 — Reserved
This option is reserved in the current ULTRA firmware, and it has no
equivalent in the ALLY PLUS.
25 — Centronics or Dataproducts Parallel
This option has no equivalent in the ALLY PLUS, because the ALLY
PLUS supports only Centronics parallel interfacing.
26 — Intervention Required
If this option is set to a value of N, ALLY PLUS Option #52 is set to 00.
The General Configuration Report will display a 0. If this option is set to
Y, the setting of ALLY PLUS Option #52 is determined by ULTRA
Option #27.
27 — Intervention Required Delay
If ULTRA Option #26 is set to Y, the setting of this option determines the
value of ALLY PLUS Option #52. The ULTRA decimal value is executed
as though it were the equivalent ALLY PLUS hexadecimal value. The
General Configuration Report will display the decimal number of minutes
selected by this option.
Note: The smallest delay allowed by the ALLY PLUS is 1 minute, while the
ULTRA can send an Intervention Required message immediately. If the
ULTRA configuration command is set to 0 (immediate), it is executed as
though it were an ALLY PLUS value of 01 (1 minute).
28 — Reserved
This option is reserved in the current ULTRA firmware, and it has no
equivalent in the ALLY PLUS.
29 — Reserved
This option is reserved in the current ULTRA firmware, and it has no
equivalent in the ALLY PLUS.