Filter
Top Products
Page 3-29CONFIGURATION
71 — MD-Laser support
The AGILE 6287 ALLY PLUS is capable of supporting the continuous
escape mode offered in Maersk Data products. If using Maersk Data
software, enable this feature.
!ALLY!71=00; feature is disabled (default)
!ALLY!71=01; feature is enabled
Note: If this option is set to 01 (enabled), Option #12 SCS right margin
and Option #22 DSC right margin should be set to 00 (infinite line
length), Option #14 SCS bottom margin and Option #24 DSC bottom
margin should be set to 00 (infinite page length), and Option #70
DisplayWrite 370 support should be set to 00 (disabled). Otherwise,
unpredictable formatting errors could occur.
72 — Metacode support
Metacode is a variation of 35h transparency (see Option #60), with the
exception that this transparency mode is handled directly by the printer,
rather than by the ALLY PLUS. When this feature is enabled, it causes the
ALLY PLUS to send the 35h character and the count byte to the printer
without any translation, rather than removing them from the data stream. It
also sends the remaining bytes in the transparent group without any
translation. Enable this option if the printer uses Metacode transparency.
Use these sequences to enable or disable this feature.
!ALLY!72=00; Metacode feature is disabled (default)
!ALLY!72=01; Metacode feature is enabled
Note: If this option is set to 01 (enabled), Option #12 SCS right margin
and Option #22 DSC right margin should be set to 00 (infinite line
length), Option #14 SCS bottom margin and Option #24 DSC bottom
margin should be set to 00 (infinite page length), and Option #70
DisplayWrite 370 support should be set to 00 (disabled). Otherwise,
unpredictable formatting errors could occur.