Filter
Top Products
Page 4-5PROGRAMMABLE FUNCTION STRINGS
%06 — Underlining On
If a [character-backspace-underline] sequence is detected in the incoming
data, this PFS will be sent out. Note: This is not used when DisplayWrite
370 is disabled (see Option #70) unless it is triggered directly by the user.
%07 — Underlining Off
If underlining was on previously, and if a [character-non-backspace]
sequence is sent to the ALLY PLUS, this PFS will be sent to the printer.
Note: This is not used when DisplayWrite 370 is disabled (see Option #70)
unless it is triggered directly by the user.
%08 — Set Line Density to 3 LPI
When a host line density command (2B C6 02 nn) is detected and nn is 18
(18h = 24/72nds), the contents of this PFS are output to the printer. Note:
This command will be seen only in an SCS data stream.
%09 — Set Line Density to 4 LPI
When a host line density command (2B C6 02 nn) is detected and nn is 12
(12h = 18/72nds), the contents of this PFS are output to the printer. Note:
This command will be seen only in an SCS data stream.
%10 — Set Line Density to 6 LPI
When a host line density command (2B C6 02 nn) is detected and nn is 0C
(0Ch = 12/72nds), the contents of this PFS are output to the printer. Note:
This command will be seen only in an SCS data stream.
%11 — Set Line Density to 8 LPI
When a host line density command (2B C6 02 nn) is detected and nn is 09
(09h = 9/72nds), the contents of this PFS are output to the printer. Note:
This command will be seen only in an SCS data stream.
%12 — Switch to Coax Host
A job boundary PFS. When the coax host becomes active, this PFS is sent
out.