Filter
Top Products
Page xixPREFACE
Warnings
Electrical Shock
Never open the ALLY PLUS when the power is on or when it is connected
to any power source. Opening the ALLY PLUS may void the warranty.
Notes
Standard Factory Setup
Unless otherwise requested, the ALLY PLUS is shipped with the following
defaults:
Other printer type (non-Xerox)
Parallel output
ASCII character set
132 column right margin
If the users equipment does not match these parameters, the relevant
configuration settings on the ALLY PLUS must be changed.
Serial Port Setup
With serial interfacing, the baud rate, parity, word length (data bits), stop
bits and handshaking settings of the ALLY PLUS must match the serial port
settings of the printer and alternate host (if using an alternate host). If the
users equipment is not set up to use the default settings, these configuration
parameters in Option Group #40 must be changed. The default settings for
the serial ports are:
9600 baud
No parity
8 data bit word length
1 stop bit
RTS/CTS flow control (handshaking)