Filter
Top Products
6
Turning On the Projector
This section describes the procedure from turning on the power to projecting images.
1
Check that the power is turned off for all
components connected to the
projector.
2
Connect the computer or other video
source to the projector.
Refer to the Setup Guide.
3
Remove the lens cap.
4
Connect the accessory power cord to
the projector.
Check that the power cord connector is facing the
same way as the power inlet on the projector, and
then insert the power cord connector securely into
the projector.
5
Connect the other end of the power
cord to a grounded electrical outlet.
The indicator will light orange and the
projector will switch to standby mode.
Connecting the Power Cord
Be sure to read the
Safety Instructions
in this manual for details on safe handling when
using the projector.
STANDBY/ON
ESCAPE MENU
ASPECT INPUT
PATTERN SETTING
Lights orange