Filter
Top Products
Advanced Operations
35
Using the Menu Functions
You can record your favorite image as a user's logo.
A user's logo can be stored for projecting when the projector starts up and when projecting the hide screen.
When a user's logo is recorded, the previous user's logo will be erased. Follow the instructions on the screen
to record a user ’s logo. (Default setting: )
•
••
• The image will be displayed in dot format while the selection frame is displayed, therefore the display size
may change.
•
••
• The size of the recorded image is 480 × 360 dots.
•
••
• Once a user's logo has been recorded, you cannot return the logo to the default setting.
•
••
• To use the stored user's logo, set "Hide Screen" to "Logo".
User’s Logo
On-Screen Display
Main menu Function
Default
setting
Menu Position If using the projector's control panel, press the , , and buttons to set the
menu display position. If using the remote control, tilt the button horizontally and
vertically.
Center
Navigation Bar This sets the menu navigation bar to be displayed (ON) or not displayed (OFF). ON
Menu Color This selects the color of the main menu for full menus and the navigation bar to one of 4
choices.
Color 1
Message This sets whether the following message is displayed (ON) or not displayed (OFF).
•
••
•
Command name display when image signal, picture mode, aspect, test pattern or
memory settings are retrieved.
•
••
•Messages such as when no image signals are being input, when an incompatible signal
is input, and when the internal temperature rises
ON
Hide Screen This sets the screen status when the button on the remote control is pressed. The
screen status can be selected from "Black", "Blue" or "Logo".
Black
Startup screen This sets whether a startup screen (an image that is projected when projection starts) is to
be displayed (ON) or not displayed (OFF). When this setting is changed, turn off the
power, and when the cool-down
period has finished, turn the power back on again. The
new setting will be applied after the power turns back on.
ON
Set the zoom rate
Zoom rate
[User 's Logo]
ESC
:Return :Select :Execute
100%
200%
300%
ESC
:Return :Select :Setting
Selection frame
Move the selection frame so that
the area of the image to be
recorded is inside the frame.
Select the display ratio.
Record
−
HIDE