Filter
Top Products
44
When the Indicators Provide No Help
If any of the following problems occur and the indicators do not offer a solution, refer to the pages given for
each problem.
No images appear
Probable relating to images
No images appear
Projection does not start, the projection
area is completely black, the projection
area is completely blue, etc.
See
below
Image colors are not right
The whole image appears purplish or
greenish, images are black & white,
colors appear dull, etc.
(Computer monitors and LCD screens
have different color reproduction
performance, so that the colors projected
by the projector and the colors appearing
on the monitor may not necessarily
match, but this is not a sign of a
problem.)
(p.47)
The message "Not Supported."
is displayed
(p.45)
The message "No Signal." is
displayed
(p.45)
Images are fuzzy or out of
focus
(p.45)
Interference or distortion
appear in images
(p.46) Images appear dark (p.47)
Problems such as interference, distortion or black &
white checked patterns appear.
Projection stops automatically (p.47)
Image is truncated (large) or
small
(p.46) Vertical lines appear in the
projected images
(p.47)
Only part of the image is displayed.
Problems when projection starts Probable with the remote control
Power does not turn on (p.48) The remote control does not
work
(p.48)
Problems relating to images
Have you pressed the [Power] button?
Press the button on the remote control, or press the
[STANDBY/ON] button on the projector's control panel.
Was the indicator lit orange before
the power was turned on?
Disconnect the power cord and then reconnect it. (p.6)
Check the circuit breaker to see if power is being supplied.
Is the hide screen activated?
Press the button on the remote control to cancel the hide
screen.
Is a video signal being input?
Check that the power supply for the connected equipment is
turned on. If the "Message" menu command is set to "ON", a
message regarding the image signal will be displayed.
"Setup" - "On-Screen Display" - "Message" (p.35)
Are the image signal format settings
correct?
Set the "Video Signal" command to match the equipment's signal
format.
"Setup" - "Input Signal" - "Video Signal" (p.36)
Is a menu setting incorrect?
Try resetting all of the current settings. (p.36)
Were the projector and the computer
connected while their power was turned
on?
If the connection is made while the power is already turned on, the
function (Fn) key that switches the computer's video signal to
external output may not work. Turn off the power for the projector
and the computer and then back on again.
Is the computer display output set to
only the computer's accessory screen?
The image signals need to be output externally. Change the output
setting to an external destination only or to an external destination
as well as the computer's own monitor.
Computer documentation, under a title such as "External output"
or "Connecting an external monitor"
HIDE
Only when projecting
computer images
Only when projecting
computer images