Filter
Top Products
9
Basic Operations
Turning Off the Projector
Follow the procedure below to turn off the power of the projector.
1
Turn off the power for the signal
sources that are connected to the
projector.
Check that the power for all connected
components has been tuned off.
2
Press the [STANDBY/ON] button on the
projector's control panel or the
button on the remote control.
The confirmation message shown at left will
appear.
If you do not want to turn off the power, press any
button except the [STANDBY/ON] button.
If you do not carry out any operation, the
message will disappear after seven seconds. (The
power will not turn off at this time.)
3
Press the [STANDBY/ON] button on the
projector's control panel or the
button on the remote control once
more.
The lamp will switch off, the indicator will
flash orange and cool-down
will start.
The remote control and the projector's control
panel cannot be operated while cool-down is in
progress (about 30 seconds).
After cool-down is complete, the indicator
will change to lit orange (standby mode).
4
If not using the projector for long
periods of time, disconnect the power
cord plug from the wall outlet.
Always make sure that the projector is in standby
mode before disconnecting the power cord.
The indicator will continue to light for a
short period after the power cord is disconnected,
and then it will turn off.
Power OFF?
Ye s
No
:
:
Press button
Press any other button
STANDBY/ON
STANDBY/ON
ESCAPE MENU
ASPECT INPUT
PATTERN SETTING
MENU
PAT TIRIS
SETTING
FOCUS
ESCAPE
ZOOM
Projector
Remote control
Do not disconnect the power cord while the projector is projecting or while
cool-down is in progress. If the power cord is disconnected at times such as
when projection is in progress, wait for the lamp to cool down (normally about
one hour is required) before turning the power back on again. If the power is
turned off and on before the lamp has cooled down, it may result in lamp
operating errors. Refer to "Lamp operating error" on page 42.